Just look

Wiring-a-ceiling-fan-with-two-light-switches, the ceiling fan with two switches will have two sets of wires. this means that you will have black, red, white and bare. the hot wires are either black or red, the white wires are neutral, and the bare one is the ground wire. screw the fan in place.. Ceiling fan wiring (two switches) this ceiling fan wiring configuration is quite common. this setup allows you to control the light and fan separately., wiring ceiling fan and light with separate switches this method allows you to operate the fan and light power separately. your power supply line (the black wire) should be feeding both switches and those switches power the fan (black) or the light (blue). to do this method, the wire from your wall circuit to your light has to have 3 wires..

Double pole switch as a single kit wiring diagram flush mount switch wiring three lights simple 3way switch ceiling fan light switch stuck wiring replacing…, the two core plus ground is the incoming feed to the light fixture. with a single load, typically a further two core would be used to carry the live out to the switch and back, by wire-nutting the two together (or using a spare terminal on the light fixture, and thw switched return and the white neutral would then go to the light..

Ceiling fan and light kit control options. there are several ways to control ceiling fans and light kits. one wire/switch - to turn power on/off to the fan (and lights) at the same time two wire/switches - one switch turns power on/off to the fan, the other to the lights pull chains - to adjust fan speed and lights remote control - available on new or existing fans to adjust fan speed and lights, a remote-controlled ceiling fan bypasses one of the wall switches and allows for remote access to the ceiling fan's workings. there is a remote inside the inner working of the fan, which responds to a remote control..

This is the updated wiring for this arrangement with a 2-wire cable added between the fan/light and switches. the white wire is no longer used for hot and instead, the source neutral is run through to the switch box to satisfy the 2011 nec requirement., our house had a ceiling fan installed outside under the covered patio before we moved in. it was obviously not intended for outdoor use and was looking terrible so we decided to replace it with an outdoor rated fan. inside the back door we have 2 switches, one controlled the light and the other the....

Here is a quesion from a site visitor asking how to wire a ceiling fan and light kit with separate control switches for the fan and the light.